MDM Two Car Instant Garage House Style 22'W x 24'L x 12'H

When more space is needed, our Two Car unit is ideal. The unit can easily handle two standard or oversize vehicles. With a width of 22', there is more than enough room to put two vehicles inside and still open the doors or hoods wide. With a length of 24', it is perfect for limousines, larger pickup trucks or vans, and still have enough space left over for a workbench or other small equipment storage. Heavy duty 2-3/8" diameter tubing makes up the arches that form the house style (ridge) roofline. With a triple zipper door on each end, easy individual vehicle entry/exit is achieved. Roll up door kits are supplied for one end as standard, along with a full anchoring kit. Available in green, gray, or tan, the two car is one of our most popular sizes.

Our 2 Car Portable Garage makes a great workshop or car storage because of the high side wall clearance. The lowest point of the portable garage is 7' at the side walls. Our 2 Car Portable Garage comes standard with front and rear doors for drivet-thru capability. Our 2 Car garage also comes with 2 roll-up door kits so you can open either panel to access the vehicle.

Typical uses include:

Vehicle protection and storage

Equipment / material storage

Workshop areas

Our pre-drilled frames are easily assembled with minimal hand tools. (Unlike other products where drilling or field cutting is required). Main cover and doors are made from long life UV Resistant and Fire Retardant Poly with Fabric Backing. All fabric components feature heat welded seam construction. Unit features double zipper doors on both ends to allow drive though capability, and good ventilation. Each door contains a pocket for a rigid pole and grommets for securing them up during use. Each unit comes equipped with fourteen (14) earth anchors with a 36” stainless steel tether and a drive rod to secure the unit at all strategic points, plus one complete roll-up door kit. (enough for one end)

Exclusive 2 Car Garage Features

2-3/8" Heavy Duty Galvanized Finish on All Steel Frame Components for Maximum Strength & Long Life

Easy Bolt Together Design - all Pre-drilled & Cut

Wind Brace Support on all 4 corners

Two(2) 20'x6'6" Triple Zipper Doors with Bottom Pockets

One (1) complete Roll-up Door Kit

Protective Plastic Tube End Caps - All Open Ends

Standard Thread Plated Hardware Kit with Retaining

Nuts & Protective SS Washers

Quick Assembly Wrench included

Heavy Duty Poly Rope for Main Cover Tie Down

Heavy Duty Grommets on Cover & Doors

Six Box Shipment - easily unloaded and transported

Average Install time - 2 hours

Colors Available: Green, Gray, & Tan

- UV Protection

- Fire Rated (CPAI -84 Section 5)

- Dual Purpose Protection!